HiResCovers.net

Here's what I started for 9, I rendered out the complete bottom part of the official movie teaser, but the bottom looks awkward because I covered up the logos at the bottom.

I can't find a poster without the letters, clearly you can see that the background and everything else behind that was put together by me.

Here is the poster without the logos etc...

sauron wrote:

QUOTE (sauron @ Dec 5 2010, 11:14 PM) <{POST_SNAPBACK}>

Here is the poster without the logos etc...

This is very useful, thanks, I replaced the bottom, here's a larger image.

Looks great. I would maybe tone down the 2 other characters as they stand out a bit.

sauron wrote:

QUOTE (sauron @ Dec 5 2010, 11:54 PM) <{POST_SNAPBACK}>

Looks great. I would maybe tone down the 2 other characters as they stand out a bit.

They need to be that way Sauron 'cause the lamp and TT light are above them.

Looking at it again it looks okay. How about increasing the saturation like this...?

sauron wrote:

QUOTE (sauron @ Dec 6 2010, 12:03 AM) <{POST_SNAPBACK}>

Looking at it again it looks okay. How about increasing the saturation like this...?

That actually looks much better, here's an update on the spine, I'll try to emulate how you increased the saturation.

The quote on the front is too big and I'm not too sure about the font, have you tried others? Also why is there three 9's on the spine?

I'm having some trouble with the spine, the logo is so small that without the after-image effect, it looks empty.

I'll try some different fonts for the front, if nothing works, I'll remove it.

I think it would look find with just one 9.