no because I have tried doing it for him and it said the same to me too (IMG:http://www.hirescovers.net/forum/style_emoticons/default/unsure1.gif
Then with the foil paper i printed the stones out on place 1 in the area you just cut out and then glue the inlay cover over the top make sure you place it right so the inside of the case displays a sililar images to that of the front any excess white paper showing trim the edges..
Once done allow the glue to dry for about 10 mins then insert the cover in the case
Now we have the main case sorted time for the bit thats got every curious and thats the lid:)
get you lid that is glued together and ready it for the laminator
Once the laminating is done where the lid will be fitted make sure there is a 1 inch overlap of the maniating sheet left.
Now in last pic you can see the overlap to get it to bend more gently score the edge between your lid and the excess laminate for desired effect.
then glue the edge of the overlapping laminated to stick to case.
Once all this is done you have the end results posted below at different angles
Hope this helps everyone on what i was planning for this cover and a very big special THANK YOU to Lulubelle for the extrodinary cover for this film.
Aslo if you look at the finished article you can see the reflection and effect of the foil stones (IMG:http://www.hirescovers.net/forum/style_emoticons/default/thumb.gif